Edelbrock Manifolds |
Part # |
Description |
Price |
2111 |
Chevrolet 90° V6
PERFORMER 90° V6 (idle-5500 rpm)
Performer 90° V6 Intake Manifold
- Chevy 200/229/262ci 3.8/4.3L 1985-95
- 4-bbl Square-Bore Carb Flange (non-EGR)
- Idle-5500 RPM Range
Designed for street 1985-95 200-229-262 c.i.d. (3.8 and 4.3L) Chevy V6s. Will not accept stock automotive carbs or 262 T.B.I. unit.
Dual bolt pattern waterneck fits both automotive and marine applications. Produced 18 more horsepower than an older manifold design on 4.3L marine engine
Throttle response is excellent Performers are ideal for stock or mildly modified marine engines. These manifolds can be ordered hard anodized to prohibit corrosion in saltwater environments. |
$209.95 |
Carburetor Recommendations: Edelbrock Performer Series carb, 500 cfm
(see Carbs & Accessories)
Installation Notes: Recommended intake gasket: Fel-Pro #1202.
Manifold height: A-3.50", B-4.18"
Fits Mercruiser/Volvo Non Vortec Heads.
Will not work with stock Carb.
May require Carb Spacer to clear Thermostat Housing.
May require Jetting Kit. |
|
MARINE CARBURETORS
For use in marine applications, these Edelbrock carbs comply with U.S. Coast Guard safety standards. Cast surfaces are iridited with PTFE-coated shafts and pump arm for maximum protection. Other features include modified bowl venting, specially designed throttle shafts, accelerator pump seal, 3/8" inverted flare fuel inlet fitting, tube in airhorn for fuel pump vent, 5-1/8" flame arrestor flange, universal throttle lever and revised secondaries for improved transient performance. Note: These carbs have no vacuum ports and are not for automotive use. Use our Carb Stud Kits #8008 or #8024 if needed, |
|
EDELBROCK MARINE SERIES 600 CFM, ELECTRIC CHOKE CARBURETORS
CALIBRATED FOR PERFORMANCE
Designed and calibrated for optimum marine performance in small-block V8 engines with a variety of manifolds that include Edelbrock Performer, Performer RPM, RPM Air-Gap, Torker II and other brands of similar design. Also ideal for Chevy 4.3L V6 engines with a Performer manifold (see Manifolds) and Calibration Kit #1485. Comes with: Metering Jets - Primary .098, Secondary .101; Metering Rods - .068 x .047; Step-Up Spring - orange (5" Hg). |
|
EDELBROCK MARINE SERIES 750 CFM, ELECTRIC CHOKE CARBURETORS
CALIBRATED FOR PERFORMANCE
Designed and calibrated for optimum marine performance in small-block and big-block V8 engines with Performer RPM, RPM Air-Gap and Torker II manifolds and with Performer manifolds on large cubic-inch engines. Comes with: Metering Jets - Primary .113, Secondary .107; Metering Rods - .071 x .047; Step-Up Spring - orange (5" Hg). |
|
|
|
|
|
|
|
|
|